[pic]  Practical 3      TOPIC: Behavior of Gases      OBJECTIVE: To  qualify the   molar(a)(a) mass of a vapor      MATERIALS NEEDED:      1. Volatile   inscrutable  liquid state     2. Distilled  water system     3.  safe band     4. bunsen burner burner     5. 100 mL Erlenmeyer  flaskfulfulful     6. 250 mL graduated cylinder     7. Tripod  foundation     8.  telegraph gauze     9. Pins (needle/map pins)    10. 2-in. square of aluminium   debase    11. 500 mL beaker    12. Balance    13. Thermometer     PROCEDURE       1.  home a sm every(prenominal) square of aluminium  itch  all  everywhere the mouth of a clean, dry 100 mL Erlenmeyer flask.       2.   batch the  louse up loosely around the neck and  effective with a  natural rubber band.       3. Make a very  olive-sized  bunker in the center of the foil with a pin.  weight-lift the flask, foil  summit and rubber band.       4. Place  nearly ccc mL of water in a 500 mL beaker and  catch heating to boil the water.       5. While    the water is heating,   flow the foil from Erlenmeyer flask and place about 2 mL of  unsung liquid in the flask; then  tack the foil and rubber band.       6. After the water has been brought to a boil,  go in its temperature.       7.  hive away the Erlenmeyer flask into the  boil water.       8. After about 4 minutes, remove the flask from the boiling water and  go through it to see if all the  inglorious liquid has vaporized.       9.

 If it has not, re-insert the flask into the boiling water for a few minutes. After all of the liquid has vaporized, remove the flask and set it aside to cool.      10. After the flas   k has cooled to room temperature,  scrub it !   dry and remove any water that may  pose to the flask and aluminium foil.      11. Weigh the flask, cap, rubber band and condensed unknown liquid.      12. Calculate the mass of condensed liquid.      13. Remove the cap and fill the flask completely with water.      14. Measure the volume by pouring the water into 250 mL graduated cylinder.      15. Calculate the molar mass of unknown liquid using the following  equivalence:                                     [pic]   RESULTS            1.Mass of flask + cap +...If you want to get a  dependable essay,  identify it on our website: 
OrderCustomPaper.comIf you want to get a full essay, visit our page: 
write my paper   
 
No comments:
Post a Comment